Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you review the Wiper/Washer operation and perform the necessary inspections? | -- | Go to Step 2 | |
2 |
Does the voltage measure near the specified value? | B+ | Go to Step 4 | Go to Step 3 |
3 | Use a DMM in order to backprobe CKT 92 (PPL) cavity E3 at the front wiper/washer switch C201 connector to ground. Does the voltage measure near the specified value? | B+ | Go to Step 5 | Go to Step 6 |
4 | Replace the front windshield wiper motor and module. Refer to Windshield Wiper System Module Replacement . Did you complete the replacement? | -- | Go to Step 7 | -- |
5 | Repair the open in CKT 92 (PPL). Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | Go to Step 7 | -- |
6 | Replace the front wiper/washer switch. Refer to Multifunction, Turn Signal and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Standard Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle in Steering Wheel and Column - Tilt. Did you complete the replacement? | -- | Go to Step 7 | -- |
7 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
