Removal Procedure
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing
any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to
the vehicle or its components.
- Disconnect
the negative battery cable.
- Relieve the fuel pressure. Refer to
Fuel Pressure Relief
.
Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a
hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
- Raise the
vehicle. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Remove the fuel tank. Refer to
Fuel Tank Replacement
.
- Remove the fuel tank pressure sensor (1) from the modular fuel
sender (2).
Installation Procedure
- Install the fuel tank
pressure sensor (1) to the modular fuel sender (2).
- Install the fuel tank. Refer to
Fuel Tank Replacement
.
- Lower the vehicle.
- Refill the fuel tank.
- Tighten the fuel filler cap.
- Connect the negative battery cable.
- Inspect for fuel leaks.
7.1. | Turn ON the ignition for 2 seconds. |
7.2. | Turn OFF the ignition for 10 seconds. |
7.3. | Turn ON the ignition. |
7.4. | Inspect for fuel leaks. |