Did you perform the Power Door Locks Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Power Door Systems

1. Disconnect the inoperative door lock motor.
2. Connect a test lamp from CKT 294 (TAN) of the inoperative motor connector to ground.
3. Place 1 of the door lock switches in the UNLOCK position.

Does the test lamp light?

--

Go to Step 4

Go to Step 3

Repair the open in CKT 294 (TAN) between the inoperative door lock motor and splice S230.

Is the repair complete?

--

Go to Step 7

--

1. Connect a test lamp from CKT 294 (TAN) to CKT 295 (GRY) at the inoperative door lock motor.
2. Place 1 of the door lock switch in the LOCK position.

Does the test lamp light?

--

Go to Step 6

Go to Step 5

Repair the open in CKT 295 (GRY) between the inoperative door lock motor and splice S228.

Is the repair complete?

--

Go to Step 7

--

Replace the inoperative door lock motor.

Is the repair complete?

--

Go to Step 7

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2