GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Astro - 2WD 🢒 Body and Accessories 🢒 Doors 🢒 Power Accessory Switch Panel Replacement

Removal Procedure
  1. Remove the armrest screws and the armrest. (YC5).
  2. Remove the window handle, if equipped.

    3. Object Number: 319092 Size: SH
  3. Pull out on the escutcheon in order to remove the lock lever escutcheon. Start with the front edge of the escutcheon.
  4. Remove the upper corner trim using the following method:
    5. 4.1. Pull the upper corner trim at the top edge.
    4.2. Pivot the upper corner trim down in order to clear the tab at the time panel (YC6 and YC7).
  5. Remove the caps that cover the screws for the assist handle.
  6. Remove the screws that retain the assist handle to the door.
  7. Remove the screw at the front edge of the accessory switch mount plate.
  8. Remove the plate from the trim panel.
  9. Disconnect the electrical connectors from the switches on the plate, as needed.

Installation Procedure

    Object Number: 319092 Size: SH
  1. Connect the electrical connectors to the switches on the accessory switch mounting plate, as needed.
  2. Install the plate to the trim panel.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the screw at the front edge of the accessory switch mount plate.

    4. Tighten
    Tighten the screws at the front edge of the accessory switch mount plate to 5 N·m (44 lb in).

  4. Install the assist handle and screws to the door.

    5. Tighten
    Tighten the assist handle screws to 5 N·m (44 lb in).

  5. Install the caps that cover the screws on the assist handle.
  6. Insert the tab in the slot on the door trim panel.

    7. Seat the fastener into the door at the top (YC6 and YC7) in order to install the upper corner trim.

  7. Snap the lock lever escutcheon into place in order to install the lock lever escutcheon. Start at the rear edge of the escutcheon.
  8. Install the window handle, if equipped.
  9. Install the armrest and armrest screws. (YC5).

    10. Tighten
    Tighten the armrest screws to 5 N·m (44 lb in).