Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

1. Remove the swing-out window latch from the door, if equipped. Refer to Swing Out Window Replacement .
2. Remove the door handle bezel screws.
3. Remove the door handle bezel.



4. Use J 38778 in order to release the molding retainers.

1. Install the door garnish molding to the vehicle:

1.1.	Align the retainers to the holes in the door.

1.2.	Press the panel in order to engage the retainers into the door.

2. Install the door handle bezel to the door.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the door handle bezel screws.

Tighten
Tighten the door handle bezel screws to 2 N·m (18 lb in).

4. Install the swing-out window latch to the door, if equipped. Refer to Swing Out Window Replacement .