GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Astro - 2WD 🢒 Body and Accessories 🢒 Doors 🢒 Rear Side Door Center Roller Bracket Replacement

Removal Procedure
  1. Remove the center roller track cover. Refer to Rear Side Door Center Track Cover Replacement .

    2. Object Number: 324152 Size: SH
  2. Position the sliding door inward for door clearance.

    3. Remove the bolts (5) that retain the center roller bracket (2) to the door.

  3. Disconnect the retaining spring located around the pin in order to release.
  4. Support the sliding door at the bottom rear corner.
  5. Slide the bracket rearward.
  6. Remove the bracket (2) from the center roller track.

Installation Procedure
  1. Install the bracket (2) to the center roller track.
  2. Slide the bracket forward.
  3. Remove the support from the sliding door.
  4. Push the retaining pin back in place.
  5. Check the retaining spring located around the pin for damage. If damaged, replace the spring.

    6. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 324152 Size: SH
  6. Install the bolts (5) that retain the center roller bracket to the door.

    7. Tighten
    Tighten the center roller bracket retaining bolts to 35 N·m (26 lb ft).

  7. Install the center roller track cover. Refer to Rear Side Door Center Track Cover Replacement .