GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the swing-out window latch. Refer to Swing Out Window Replacement in Stationary Windows.

  2. Object Number: 324182  Size: SH
  3. Remove the screws that retain the right molding on the sides and the bottom.

  4. Object Number: 324181  Size: SH
  5. Remove the screws that retain the left molding on the sides and the bottom.
  6. Remove the molding from the door in the area of the retainers.
  7. There are 2 retainers on top, one in the center of the panel, and 6 around the outside edge.

Installation Procedure


    Object Number: 324181  Size: SH
  1. Install the left molding to the door:
  2. 1.1. Place the retainers into the holes.
    1.2. Press on the panel at the retainer locations until the retainers are fully seated.

    Object Number: 324182  Size: SH
  3. Install the right molding to the door:
  4. 2.1. Place the retainers into the holes.
    2.2. Press on the panel at the retainer locations until the retainers are fully seated.

    Notice: Refer to Fastener Notice in the Preface section.

  5. Install the screws that retain the panel to the door.
  6. Tighten
    Tighten the screws that retain the panel to the door to 2 N·m (18 lb in).

  7. Install the swing-out window latch. Refer to Swing Out Window Replacement in Stationary Windows.
  8. Ensure that the weatherstrip fits into the corner and matches the corner of the radius of the body flange.
  9. Ensure that the weatherstrip is seated completely onto the flange in all areas, resulting in a smooth, vinyl trim around the entire door opening.
  10. Important: When using the rubber mallet, the weatherstrip must be hit square to the flange. Otherwise, an undesirable spreading of the carrier will occur, resulting in reduced retention.

  11. Ensure that there is no distortion or excessive spreading of the carrier as a result of hitting the carrier improperly with the rubber mallet.
  12. Lubricate the weatherstrip with GM Weatherstrip Silicone Lubricant P/N 12345579 or equivalent.