Because the compass system is so complex and susceptible to outside influences, examine the system thoroughly before performing any repairs. Diagnose the system in an area free from potential interference, such as an open field. Recalibrate the system before performing any other repairs in order to verify the existence of a problem. Refer to Electronic Compass Operation in Instrument Panel, Gages and Console.

1. Remove the retaining screws from the overhead console.

1.1.	Remove the dome lamp lens from the overhead console.

1.2.	Remove the front screws from the overhead console.

1.3.	Remove the rear screws from the overhead console.

2. Disconnect the electrical connector from the dome lamp harness.
3. Remove the overhead console as follows:

3.1.	Swing the overhead console downward.

3.2.	Pull the overhead console forward in order to clear the rear mounting tabs.

1. Install the rear part of the overhead console by inserting the mounting tabs into the roof panel.
2. Connect the electrical connector to the dome lamp harness.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the overhead console retaining screws.

Tighten
Tighten the screws to the overhead console to 2 N·m (18  lb in).

3.1.	Install the rear screws to the overhead console .

Tighten
Tighten the rear screws to the overhead console to 2 N·m (18  lb in).

3.2.	Install the front screws to the overhead console .

Tighten
Tighten the front screws to the overhead console to 2 N·m (18 lb in).

3.3.	Install the dome lamp lens to the overhead console .