Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

1. Open the rear door(s).



2. Remove the screws from the panel in the rear door opening.
3. Use J 38778 in order to release the fasteners that retain the panel to the vehicle.
4. Disconnect the speaker electrical connector, if equipped.

1. Connect the speaker electrical connector, if equipped.



2. Install the panel to the vehicle:

2.1.	Align the retaining clips with the holes in the body.

2.2.	Press the panel down in order to seat the fasteners into place.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the screws to the panel in the rear door opening.

Tighten
Tighten the screws to the panel in the rear door opening to 2 N·m (18 lb in).