Tools Required

J 34730-1A Fuel Pressure Gage

Caution: Remove the fuel tank cap and relieve the fuel system pressure before servicing the fuel system in order to reduce the risk of personal injury. After you relieve the fuel system pressure, a small amount of fuel may be released when servicing the fuel lines, the fuel injection pump, or the connections. In order to reduce the risk of personal injury, cover the fuel system components with a shop towel before disconnection. This will catch any fuel that may leak out. Place the towel in an approved container when the disconnection is complete.

1. Turn OFF the ignition.
2. Disconnect the negative battery cable in order to avoid possible fuel discharge if an accidental attempt is made to start the engine. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
3. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
4. Connect the J 34730-1A or the equivalent to the fuel pressure connection.
5. Wrap a shop towel around the fitting while connecting the gage in order to avoid spillage.
6. Install the bleed hose of the gage into an approved container.
7. Open the valve on the gage in order to bleed the system pressure. The fuel connections are now safe for servicing.
8. Drain any fuel remaining in the gage into an approved container.