Important: After removing the MAP sensor from the intake manifold, replace the MAP sensor to intake manifold seal.

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.



3. Disconnect the MAP sensor harness connector.



4. Remove the MAP sensor.
5. Discard the MAP sensor grommet.

1. Install a new MAP sensor grommet if the old MAP sensor is being reused.



2. Install the MAP sensor.



3. Connect the MAP sensor harness connector.
4. Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
5. Connect the negative battery cable.