Front Lower Control Arm Bushing Replacement Rear Wheel Drive (Front)

Tools Required

1. Remove the lower control arm. Refer to Lower Control Arm Replacement .
2. Place the lower control arm in a vise.



3. Using a blunt chisel, drive the bushing flare down flush with the rubber part of the bushing.
4. Remove the front bushing.

4.1.	Install the J 21474-5 , the J 21474-18 , the J 21474-19 , the J 21474-23 and the J 22222-5 as shown.

4.2.	Tighten until the front bushing comes free.

1. Install the front bushing.

1.1.	Install the J 21474-5 , the J 21474-12 , the J 21474-18 , the J 21474-19 and the J 21474-20 as shown. The lip is on the outside of the control arm.

1.2.	Tighten until the front bushing seats fully into the lower control arm.

2. Flare the front bushing.

2.1.	Install the J 21474-5 , the J 21474-12 , the J 21474-18 , the J 21474-19 and the J 21474-20 as shown.

2.2.	Tighten until the bushing is flared to approximately 45 degrees.

3. Remove the lower control arm from the vise.
4. Install the lower control arm to the vehicle. Refer to Lower Control Arm Replacement .

Front Lower Control Arm Bushing Replacement Rear Wheel Drive (Rear)

Tools Required

1. Remove the lower control arm. Refer to Lower Control Arm Replacement .
2. Place the lower control arm in a vise.



3. Remove the rear bushing.

3.1.	Install the J 21474-5 , the J 21474-8 , the J 21474-12 , the J 21474-18 and the J 21474-19 as shown.

3.2.	Tighten until the rear bushing comes free.

1. Install the rear bushing into the lower control arm.

1.1.	Install the J 21474-5 , the J 21474-18 , the J 21474-19 , and the J 21474-20 as shown. The lip is on the outside of the control arm.

1.2.	Tighten until the rear bushing seats fully into the lower control arm.

2. Remove the lower control arm from the vise.
3. Install the lower control arm to the vehicle. Refer to Lower Control Arm Replacement .

Front Lower Control Arm Bushing Replacement Full-Time Four-Wheel Drive

Tools Required

1. Remove the lower control arm. Refer to Lower Control Arm Replacement .
2. Remove the front bushing.

2.1.	Unbend the crimps using a punch.

2.2.	Remove the bushing using the J 36618-2, the J 9519-23, the J 36618-4, and the J 36618-1.

3. Remove the rear bushing (no crimp). Remove the bushing using the J 36618-5, the J 36618-3, the J 36618-2, and the J 9519-23.

1. Install the front bushing using the J 36618 and the J 9519-23 . After installing the bushing, crimp the bushing into place.
2. Install the rear bushing using the J 36618 and the J 9519-23 .
3. Install the lower control arm. Refer to Lower Control Arm Replacement .