GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Astro - 4WD 🢒 Restraints 🢒 Seat Belts 🢒 Seat Belt Retractor Replacement - No. 2 Right Rear

Removal Procedure

    Object Number: 162202 Size: SH
  1. Remove the trim cover from the rear seat belt retractor, by grasping the sides and pull downward.
  2. Remove the seat belt retractor buckle from the latch.
    3. 2.1. Locate the red dot in the center of the buckle.
    2.2. Insert a small pointed tool in the center of the buckle.
    2.3. Push inward for it to release from the latch.

    Object Number: 162207 Size: SH
  3. Remove the rear seat belt retractor nuts from the roof reinforcement.
  4. Remove the rear seat belt retractor from the vehicle.

Installation Procedure
  1. Install the rear seat belt retractor to the vehicle.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 162207 Size: SH
  2. Install the rear seat belt retractor nuts to the roof reinforcement panel.

    3. Tighten
    Tighten the seat belt retractor nuts to 35 N·m (26 lb ft).

  3. Snap the retractor cover into place.

    4. Object Number: 162202 Size: SH
  4. Install the seat belt buckle to the latch.