Step
| Action
| Value(s)
| Yes
| No
|
1
| Did you perform the Exterior Lights System Check?
| --
| Go to
Step 2
| Go to
Exterior Lights System Check
|
2
|
- Place the ignition switch in the RUN position.
- Turn the hazard flashed switch OFF.
- Place a turn signal ON.
Does the turn signal operate?
| --
| Go to
Step 3
| Go to
Turn Signal Lamps Inoperative
|
3
|
- Place the turn signal in the OFF position.
- Disconnect th e turn/hazard switch (part of C201).
- Connect a test lampJ 35616-200
from CKT 140 cavity E8 at C201 to ground.
Does the test lamp light?
| --
| Go to
Step 4
| Go to
Step 5
|
4
|
- Reconnect the turn signal switch.
- Turn the haz ard flashers ON.
- Use a test lampJ 35616-200
to backprobe CKT 61 (LT GRN) cavity E1 at the
connector C201 to ground.
Does the test lamp light?
| --
| Go to
Step 6
| Go to
Step 7
|
5
| Repair the open in CKT 140 (ORN) from the turn signal
switch to the instrument panel fuse block.
Is the repair complete?
| --
| Go to
Exterior Lights System Check
| --
|
6
| Repair the open in CKT 61 (LT GRN) between
the turn signal switch and S208.
Is the repair complete?
| --
| Go to
Exterior Lights System Check
| --
|
7
| Replace the turn/hazard switch. Refer to one of the following
diagnostic tables:
| • | Infl Rst Steering Wheel Module Coil - Assemble |
| • | Steering Column Tilt Head Assembly Disassemble |
| • | Steering Column Tilt Head Assembly Assemble |
Is the repair complete?
| --
| Go to
Exterior Lights System Check
| --
|
