GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Important: The CKP System Variation Learn Procedure will need to be performed whenever the Crankshaft Position (CKP) sensor is removed or replaced. Refer to Crankshaft Position System Variation Learn

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Disconnect the negative battery cable.
  2. Raise the vehicle.

  3. Object Number: 10937  Size: SH
  4. Disconnect the CKP sensor harness connector.

  5. Object Number: 10938  Size: SH
  6. Remove the CKP sensor mounting bolt.

  7. Object Number: 11485  Size: SH
  8. Remove the CKP sensor.

Installation Procedure


    Object Number: 11485  Size: SH

    Important: Inspect the sensor 0-ring for wear, cracks or leakage.

    When installing a crankshaft position (CKP) sensor make sure the sensor is fully seated and held stationary in the front cover before torquing the hold down bolt into the front cover. A sensor which is not seated may result in erratic operation and lead to the setting of false codes.

  1. Install the CKP sensor.

  2. Object Number: 10938  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the mounting bolt.
  4. Tighten
    Tighten the bolt to 20 N·m (15 lb ft).


    Object Number: 10937  Size: SH
  5. Connect the CKP sensor harness connector.
  6. Lower the vehicle.
  7. Connect the negative battery cable.
  8. Perform the CKP System Variation Learn Procedure. Refer to Crankshaft Position System Variation Learn