For 1990-2009 cars only
Removal Procedure
- Remove the nuts located on the inside of the seat riser. Refer to Bucket Seat Replacement in Seats.
- Remove the seat belt buckle from the floor stud by lifting upward on the seat. The seat doesn't have to be removed from the vehicle.
- Disconnect the seat belt buckle warning lamp electrical connector.
- Remove the seat belt buckle.
Installation Procedure
- Install the seat belt buckle.
- Connect the seat belt buckle warning electrical connector.
- Install the seat belt buckle to the floor stud.
- Install the nuts located at the base of the seat riser. Refer to Bucket Seat Replacement in Seats.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bucket seat to the floor to 35 N·m (26 lb ft).
