Rear Seat Armrest Replacement YC5 and YC6

1. Fold down the seat back.
2. Remove the upper and lower latch and hinge trim. Refer to Rear Seat Back Hinge Trim Replacement - Left Side , or Rear Seat Back Hinge Trim Replacement - Right Side .
3. Unzip the seat back trim cover.
4. Reach inside the seat back. Remove the armrest retaining clip from the stud.
5. Remove the armrest from the seat back.
6. Remove the armrest cover for cleaning or replacement, if needed:

6.1.	Unzip the cover.

6.2.	Slide the cover off the armrest.

1. Install the armrest cover to the armrest, if you removed the cover.
2. Install the armrest into the seat back
3. Reach inside the seat back. Install the armrest retaining clip.

•	Install the clip with the opening facing down.

•	Observe the fit of the clip once installed. If the clip is loose when fitted in the groove in the seat back frame, remove the clip and crimp the clip closed slightly.

•	Repeat this procedure until the clip fits snugly in the groove, or install a new clip.

4. Zip the seat back trim cover closed.
5. Install the upper and lower latch and hinge trim. Refer to Rear Seat Back Hinge Trim Replacement - Left Side , or Rear Seat Back Hinge Trim Replacement - Right Side .
6. Fold up the seat back.

Rear Seat Armrest Replacement YC7

1. Place the seat back in the fully-upright position.



2. Release the J-hook along the bottom edge of the seat back.
3. Reach up inside the seat back. Remove the armrest retaining clip.
4. Slide the armrest assembly out of the seat back.
5. Remove the armrest cover for cleaning or replacement, if needed:

5.1.	Unzip the cover.

5.2.	Slide the cover off the armrest.

1. Install the armrest cover to the armrest, if you removed the cover.
2. Reach inside the seat back. Install the armrest retaining clip:

•	Install the clip with the opening facing down.

•	Check the fit of the clip once installed. If the clip is loose when fitted in the groove in the seat back frame, remove the clip and crimp the clip closed slightly.

•	Repeat this procedure until the clip fits snugly in the groove, or install a new clip.

3. Insert the armrest into the seat back until the clip engages the groove on the armrest post.
4. Pull on the armrest in order to verify that the clip is holding the armrest securely.



5. Attach the halves of the J-hook along the bottom edge of the seat back.