Removal Procedure
- Remove the instrument panel extension. Refer to Instrument Panel Extension Replacement IP Extension Replacement .
- Remove the floor air outlet duct. Refer to Floor Air Outlet Replacement - Center in Heating, Ventilation and Air Conditioning.
- Remove the bolts from the engine cover brackets:
- Remove the latches.
- Remove the screws.
- Remove the engine cover.
| 3.1. | Loosen the bolt. |
| 3.2. | Rotate the bracket out of the way. |
Installation Procedure
- Install the engine cover.
- Install the screws to the engine cover.
- Install the latch screws.
- Install the engine cover bolts.
- Insert the floor air outlet duct. Refer to Floor Air Outlet Replacement - Center in Heating, Ventilation and Air Conditioning.
- Insert the instrument panel extension. Refer to Instrument Panel Extension Replacement .
Do not fully tighten the screws.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the latch screws to 4 N·m (35 lb in).
Tighten
Tighten the engine cove bolts to 25 N·m (18 lb ft).
