Trim Height Measurements
Trim height is a predetermined measurement relating to vehicle ride height.
Incorrect trim heights can cause bottoming out over bumps, damage to the suspension
components and symptoms similar to wheel alignment problems. Check the trim heights
when diagnosing suspension concerns and before checking the wheel alignment.
Perform the following before measuring the trim heights:
• | Make sure the vehicle is on a level surface, such as an alignment rack. |
• | Remove alignment rack floating plate pins. |
• | Check the fuel level. Add additional weight if necessary to simulate a
full tank. |
• | To ensure proper weight distribution make sure the rear storage compartment
is empty. |
• | Close the doors and hood. |
Z Height Measurement
The Z height measurement determines the proper ride height for the front end
of the vehicle. Vehicles equipped with torsion bars use an adjusting arm to
adjust the Z height. Vehicles without torsion bars have no adjustment and could require
replacement of suspension components.
Important: All dimensions are measured vertical to the ground. Cross vehicle Z heights
should be within 12 mm (0.47 in) to be considered correct.
- Place hand on the front bumper and jounce the front of the vehicle. Make
sure that there is at least 38 mm (1.5 in) of movement
while jouncing.
- Allow the vehicle to settle into position.
- For 2WD models measure from the pivot bolt center
line (3) down to the lower corner (5) of the steering knuckle (1) in order to obtain
the Z height measurement (4).
- For AWD models measure from the pivot bolt center
line (3) down to the lower corner (5) of the steering knuckle (1) in order to obtain
the Z height measurement (4).
- Repeat the jouncing operation 2 more times for a total of 3 times.
- Use the highest and lowest measurements to calculate the average height.
- The true Z height dimension number is the average of the highest and lowest
measurements. Refer to
Trim Height Specifications
.
Z Height Adjustment
- For vehicles equipped with a torsion bar suspension,
turn the bolt (1) that contacts the torsion arm as needed. One revolution of the
bolt (1) into the nut, increases the Z height by approximately 6.0 mm (0.2 in).
- For vehicles without torsion bars replace damaged or worn components
as necessary.
- If these measurements are still out of specifications after adjustment
or are not equipped with torsion bars, inspect for the following conditions:
D Height Measurement
The D height measurement determines the proper ride height for the rear end
of the vehicle. There is no adjustment procedure. Repair may require replacement
of suspension components.
Important: All dimensions are measured vertical to the ground. Cross vehicle D heights
should be within 10 mm (0.39 in) to be considered correct.
- Place hand on the rear bumper and jounce the rear of the vehicle. Make
sure that there is at least 38 mm (1.5 in) of movement while jouncing.
- With the vehicle on a flat surface, lift upward on the rear bumper 38 mm
(1.5 in).
- Allow the vehicle to settle into position.
Important: Measure the metal to metal contact points of the rear axle to the frame on the
inboard side of the leaf springs.
- Measure the D height by measuring the distance between the rear axle tube or
rear axle bracket on vehicles with 7300 GVW rating and the frame.
- Repeat the jouncing operation 2 more times for a total of 3 times.
- Use the highest and lowest measurements to calculate the average height.
- The true D height dimension is the average of the highest and the lowest
measurements. Refer to
Trim Height Specifications
.
- If these measurements are out of specifications, inspect for the following
conditions:
• | Sagging rear leaf springs |
• | Worn rear suspension components, such as leaf spring bushings. |