Removal Procedure
- Release the park brake.
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Remove the tire and wheel assembly. Refer to
Tire and Wheel Removal and Installation
in Tires and Wheels.
- Relieve the tension from the park brake cables by loosening the nut at
the equalizer.
- Remove the park brake cable from the mounting bracket by depressing the
locking tabs.
- Remove the rear park brake cable from the park brake actuator lever.
- Remove the rotor. Refer to
Rear Brake Rotor Replacement
in Disc Brakes.
- Remove the axle shaft. Refer to
Rear Axle Shaft Replacement
in Rear Drive Axle.
- Remove the park brake shoe. Refer to
Parking Brake Shoe Replacement
.
- Remove
the backing plate nuts.
- Remove the backing plate from axle housing flange.
Installation Procedure
- Install the backing plate to the axle housing flange.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the backing plate nuts.
Tighten
Tighten the backing plate bolts to 135 N·m (100 lb ft).
- Install the park brake shoe. Refer to
Parking Brake Shoe Replacement
.
- Install the axle shaft. Refer to
Rear Axle Shaft Replacement
in Rear Drive Axle.
- Adjust the park brake shoe. Refer to
Park Brake Adjustment
.
- Install the rotor. Refer to
Rear Brake Rotor Replacement
in Disc Brakes.
- Install the rear park brake cable to the park brake actuator lever.
- Install the park brake cable to the mounting bracket until the locking
tabs snap into place.
- Tighten the nut to the intermediate cable at the equalizer.
Tighten
Tighten the nut to 3.5 N·m (31 lb in).
- Install the tire and wheel assembly. Refer to
Tire and Wheel Removal and Installation
in Tires and Wheels.
- Remove the safety stands.
- Lower vehicle.
- Adjust park brake cable. Refer to
Park Brake Adjustment
.