For 1990-2009 cars only
Removal Procedure
- Release the park brake.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the threaded end of the cable from the adjuster.
- Remove the cable from the differential clip.
- Remove the cable from the backing plate by depressing the locking tabs.
- Remove the cable from the lever.
- Remove the cable.
Installation Procedure
- Install the cable taking care to correctly route the cable through the guide and the bracket.
- Attach the cable to the lever.
- Install the cable to the backing plate by pressing the cable into place until locking tabs snap into place.
- Install the cable to the differential clip.
- Install the cable to the differential clip.
- Connect the cable to the equalizer.
- Install the threaded end of the cable into the adjuster nut.
- Remove the safety stands and lower the vehicle.
- Adjust the park brake cable. Refer to Park Brake Adjustment .
Important: After installing the cable to the rear axle holding clip, verify that clip is securely retaining the cable. If not, crimp the clip by hand taking care not to pinch or kink the cable.
