Tools Required

1. Remove the clutch plate and hub assembly. Refer to Compressor Clutch Plate and Hub Assembly Removal .
2. Use the J 6083 in order to remove the following components:

•	The pulley rotor (1)

•	The bearing assembly retaining ring (2)




3. Install the J 33023-A to the front head.
4. Install the J 41552 down into the inner circle of slots (1) in the rotor.



5. Turn the J 41552 clockwise in the slots in the rotor.
6. Perform the following steps in order to remove the pulley rotor and bearing assembly:

6.1.	Hold the J 41552 in position.

6.2.	Tighten the puller screw against the puller guide.

6.3.	Remove the pulley rotor and bearing assembly.




7. Mark the clutch coil terminal location (1) on the compressor front head. Refer to Clutch Rotor and/or Bearing Removal .
8. Install the J 33023-A on the front head of the compressor.
9. Install the J 8433-1 and the J 33025 .
10. Tighten the J 8433-3 against the puller pilot in order to remove the clutch coil (2).