GM Service Manual Online
For 1990-2009 cars only

Tools Required

    • J 42220 Universal Leak Detection Lamp
    • J 44551 Suction Screen Kit

Removal Procedure


    Object Number: 812271  Size: SH
  1. Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging .
  2. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
  3. Remove the A/C compressor hose assembly bolt.
  4. Separate the A/C compressor hose assembly from the A/C compressor.
  5. Important: The suction screens are available in 3 different sizes.

  6. Select the proper size removal tool (1) from J 44551 .
  7. Remove the suction screen using the J 44551-31 suction screen removal tool.
  8. 6.1. Thread the forcing screw into the suction screen.
    6.2. Tighten the nut on the forcing screw to remove the suction screen.

Installation Procedure


    Object Number: 812268  Size: SH
  1. Insert the J 44551-6 sizing tool (1) into the suction hose to select the correct size suction screen.

  2. Object Number: 812269  Size: SH
  3. Insert the suction screen into the suction hose.
  4. Install the J 44551-3 mandrel (1) to J 44551-5.

  5. Object Number: 812270  Size: SH
  6. Install the J 44551-5 suction screen installation tool (3) over the end of the suction hose and the suction screen (2).
  7. Important: Correct placement of J 44551-5 is critical.

  8. Tighten the forcing screw of J 44551-5.
  9. The suction screen is fully installed when the screen is flush with the end of the suction hose.

  10. Remove the J 44551-5 suction screen tool from the suction hose.
  11. Replace the seal washers. Refer to Sealing Washer Replacement .
  12. Install the A/C compressor hose assembly to the A/C compressor.
  13. Notice: Refer to Fastener Notice in the Preface section.

  14. Install the A/C compressor hose assembly bolt.
  15. Tighten
    Tighten the bolt to 34 N·m(25 lb ft).

  16. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  17. Leak test the fittings of the component using J 42220 .
  18. Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.