• | J 6083 Snap Ring Pliers |
• | J 8433-1 Puller Bar |
• | J 8433-3 Forcing Screw |
• | J 33017 Pulley and Bearing Assembly Installer |
• | J 33023-A Puller Pilot |
• | J 33024 Clutch Coil Installer Adapter |
• | J 33025 Clutch Coil Puller Legs |
• | J 39400-A Halogen Leak Detector |
• | J 34992 Holding Fixture |
• | J 41552 Pulley Puller |
• | The pulley rotor |
• | The bearing assembly retaining ring |
8.1. | Hold the J 41552 in position. |
8.2. | Tighten the puller screw against the puller guide. |
8.3. | Remove the pulley rotor and bearing assembly. |
Important: Ensure that the stake size is only one-half the area of the punch tip. Ensure that the stake is only approximately 0.28-0.35 mm (0.010-0.015 in) deep.
17.1. | Loosen the J 8433-3 . |
17.2. | Realign the installer and the pilot in order to ensure that the J 33017 properly clears the front head. |
• | The pulley rotor (1) |
• | The retainer ring (2) |