Removal Procedure
- Set the parking brake, turn the ignition key to the ON position
and move the gear selector to 1st gear position.
- Lower the tilt steering column to the lowest position.
- Pull the instrument panel
cluster trim plate rearward by grasping it around the edges until the retainers
release from the instrument panel.
- Remove the auxiliary heat
blower motor switch (1) from the instrument panel cluster trim plate (3)
by releasing the tabs located on the sides of each switch.
Installation Procedure
- Install the auxiliary
heat blower motor switch (1) to the instrument panel cluster trim plate (3)
by engaging the tabs located on the sides of each switch.
- Install the instrument
panel cluster trim plate by aligning the retainers to the opening in the
instrument panel and push in place until fully seated.
- Move gear selector into PARK position, turn the ignition to the
OFF position and release the park brake.