GM Service Manual Online
For 1990-2009 cars only

Service of the powertrain control module (PCM) should normally consist of either replacement of the PCM or electrically erasable programmable read only memory (EEPROM) programming. If the diagnostic procedures call for the PCM to be replaced, the PCM should be inspected first to see if the correct part is being used. If the correct part is being used, remove the faulty PCM and install the new service PCM.

Important: To prevent internal PCM damage, the ignition must be OFF when disconnecting or reconnecting power to the PCM. For example, when working with a battery cable, PCM pigtail, PCM fuse, or jumper cables.

Important: Remove any debris from the PCM connector surfaces before servicing the PCM. Inspect the PCM module connector gaskets when diagnosing or replacing the PCM. Ensure that the gaskets are installed correctly. The gaskets prevent contaminant intrusion into the PCM.

Important: The replacement PCM must be programmed.

Removal Procedure


    Object Number: 718096  Size: SH

    Notice: Do not touch the connector pins or soldered components on the circuit board in order to prevent possible electrostatic discharge (ESD) damage to the PCM.

    Notice: In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.

  1. Disconnect the PCM harness connectors (4).
  2. Release the spring latch (3) from the PCM (1).

  3. Object Number: 718097  Size: SH
  4. Lift the PCM from the PCM mounting tray (2).
  5. Remove the PCM (1) from the engine compartment.

Installation Procedure


    Object Number: 718097  Size: SH
  1. Install the PCM (1) to the PCM mounting tray (2).
  2. Secure the spring latch (3) to the PCM (1).

  3. Object Number: 718096  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Connect the PCM connectors (4) to the PCM (1).
  5. Tighten
    Tighten the PCM connector end fasteners to 8 N·m (71 lb in).

  6. If a new PCM is being installed, program the PCM. Refer to Service Programming System (SPS) .