Removal Procedure
- Remove the IP assembly. Refer to
Instrument Panel Assembly Replacement
in Instrument Panel, Gages and
Console.
- Remove the vacuum hose from the mode actuator.
- Slide the actuator off the mounting bracket in order to remove
the actuator.
- Rotate the actuator (2) so that the actuator linkage slips off
the post on the mode door linkage.
- Remove the actuator linkage
from the mode door linkage.
Installation Procedure
- Rotate the actuator so that the actuator linkage slips over the
post on the mode door linkage.
- Install the actuator linkage
to the mode door linkage.
- Slide the actuator (2) onto the mounting bracket in order to install
the actuator.
Firmly press the actuator into place in order
to fully seat the fastener.
- Install the vacuum hose to the mode actuator.
- Install the IP assembly. Refer to
Instrument Panel Assembly Replacement
in Instrument Panel,
Gages and Console.