Caution: Refer to Cracked Window Caution in the Preface section.
Important: Before cutting out a stationary window, apply a double layer of masking tape
around the perimeter of the painted surfaces and the interior trim.
- When replacing or removing the left side stationary window .Refer to
Third Pillar Trim Replacement - Left Side
in Interior Trim
or
Fourth Pillar Trim Replacement - Left Side
in
Interior Trim.
- When replacing or removing the right side stationary window.Refer to
Third Pillar Trim Replacement - Right Side
in Interior Trim
or
Fourth Pillar Trim Replacement - Right Side
in
Interior Trim.
Caution: Refer to Defroster Outlet Caution in the Preface section.
- Cover to protect the following parts from broken glass:
| 3.2. | Defroster outlets and A/C outlets |
Caution: Refer to Glass and Sheet Metal Handling Caution in the Preface section.
- Using a sharp utility knife, make a preliminary cut around the
perimeter of the stationary window.
Important: Keep the cutting edge of the tool against the stationary window. Do this from
inside the vehicle.
- This will allow the urethane adhesive to be separated from the stationary window.
| • | Leave a base of urethane on the pinchweld flange. |
| • | The only suitable lubrication is clear water. |
| • | Use J 24402-A
, J 39032
or equivalent in order to remove
the stationary window. |
- With the aid of an assistant, remove the stationary window from the opening.
