GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 34946 Window Pin Remover

Removal Procedure

    Caution: Refer to Cracked Window Caution in the Preface section.

    Caution: Refer to Glass and Sheet Metal Handling Caution in the Preface section.

  1. Remove the swing out window latch screws.

  2. Object Number: 311701  Size: SH
  3. Remove the swing out window hinge screws.
  4. Remove the retainers.
  5. Remove the bushings.
  6. Remove the nuts.
  7. Remove the swing out window from the opening with the aid of an assistant.

  8. Object Number: 311700  Size: SH
  9. UseJ 34946 or equivalent in order to remove the pins.

  10. Object Number: 311723  Size: SH
  11. Remove the swing out window latches from the window.
  12. Remove the screws from the bearings.
  13. Remove the bearings from the window.
  14. Remove the nuts from the window.

Installation Procedure

  1. Install the bearings to the window.
  2. Install the bushings to the window.
  3. Install the nuts to the window.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the screws to the bearing.
  6. Tighten
    Tighten the screws to the bearing to 2 N·m (27 lb in).


    Object Number: 311723  Size: SH
  7. Install the latches to the window.

  8. Object Number: 311700  Size: SH
  9. Use J 34946 in order to install the pins.
  10. Install the window to the opening with the aid of an assistant.
  11. Install the hinge nuts to the stationary window.
  12. Install the bushings to the stationary window.
  13. Install the retainers to the stationary window.

  14. Object Number: 311701  Size: SH
  15. Install the hinge screws to the stationary window.
  16. Tighten
    Tighten the stationary window hinge screws to 1.6 N·m (1.4 lb in).

  17. Install the stationary window latch screws.
  18. Tighten
    Tighten the stationary window latch screws to 3.5 N·m (1.6 lb in).