Removal Procedure
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the oil filter adapter. Refer to Oil Filter Adapter Replacement .
- Remove the engine mount through-bolt and nut for the side being replaced.
- Using a jack on the square tab (left side shown) at the rear of the engine block, raise the engine only enough to remove the engine mount.
- Remove the bolts for the engine mount bracket to the engine.
- Remove the engine mount bracket.
- For AWD vehicle remove the bolts for the engine mount to the frame (left side shown).
- Remove the engine mount.
- For a RWD vehicle left side remove the bolts and the nuts for the engine mount to the frame bracket (left side shown).
- If necessary, remove the left side engine mount frame bracket from the frame.
Notice: Broken engine mountings can cause misalignment of certain drive-train components. Misalignment of drive-train components causes eventual destruction of the drive-train components.
If one engine mount breaks, the rest of the engine mounts will have increased stress put on them. This could cause the rest of the engine mounts to break.
Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Lifting the engine in an unapproved manner may cause component damage.
Access the upper two bolts for the right engine mount bracket through the fender wheelhouse.
Installation Procedure
- For AWD vehicle install the engine mount to the frame (left side shown).
- Install the AWD vehicle engine mount to the frame bolts.
- If removed, install the RWD vehicle left side bolts, nuts and engine mount frame bracket to the frame.
- Install the RWD vehicle left side engine mount, the bolts, and the nuts to the frame bracket.
- Install the engine mount bracket to the engine.
- Install the engine mount bracket bolts.
- Lower the engine.
- Install the engine mount through-bolt and the nut.
- Install the oil filter adapter. Refer to Oil Filter Adapter Replacement .
- Lower the vehicle.
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the AWD vehicle engine mount to frame bolts to 59 N·m
(44 lb ft).
Tighten
| • | Tighten the engine mount frame bracket bolts to 47 N·m (35 lb ft). |
| • | Tighten the engine mount frame bracket nuts to 42 N·m (31 lb ft). |
Tighten
| • | Tighten the engine mount to frame bolts to 47 N·m (35 lb ft). |
| • | Tighten the engine mount to frame nuts to 42 N·m (31 lb ft). |
Tighten
Tighten the engine mount bracket bolts to 64 N·m (47 lb ft).
Tighten
Tighten the engine mount through-bolt nuts to 68 N·m (50 lb ft).
