Schematic Reference: Exterior Lights Schematics

Connector End View Reference: Lighting Systems Connector End Views

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

Verify that the marker, license and tail lamps are inoperative.

Do the marker, license and tail lamps operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Disconnect the headlamp switch and connect a fused jumper between the battery positive voltage circuit input terminal and the park lamps switch signal circuit output terminal at the headlamp switch connector.

Do the marker, license, and tail lamps illuminate?

Go to Step 6

Go to Step 4

1. Remove the park lamp relay.
2. Test for an open or high resistance in the park lamp relay control circuit or an open, high resistance or short to ground in the following circuits. Refer to Circuit Testing in Wiring Systems.

•	Battery positive voltage

•	Park lamps supply voltage

Was a problem found?

Go to Step 5

Go to Step 7

Repair the open, high resistance or short to ground in one of the following circuits. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

Go to Step 8

--

Replace the headlamp switch. Refer to Headlamp Switch Replacement .

Is the repair complete?

Go to Step 8

--

Replace the park lamp relay.

Is the repair complete?

Go to Step 8

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3