Disassembly Procedure
Caution: Refer to SIR Caution in the Preface section.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.
- Remove the upper and lower trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Remove the wire harness assembly (4) out of the wire harness
strap (5).
Remove the wire harness straps (3) from
the wire harness assembly (4).
Remove the wire harness
strap (2) from the upper tilt head assembly (1).
- Slide the 2 connectors (2)
off from the bulk head connector (1).
- Remove the key alarm connector (1)
from the ignition lock cylinder case (2).
- Remove the 2 tapping screws from the ignition switch assembly (3).
- Remove the ignition switch assembly (3).
Assembly Procedure
- Install the ignition switch
assembly (3) onto the ignition lock cylinder case (2).
Notice: Refer to Fastener Notice in the Preface section.
- Install the 2 tapping screws into the ignition switch assembly (3).
Tighten
Tighten the screws to 1.5 N·m (13 lb in).
- Install the key alarm connector (1) to the ignition lock
cylinder case (2).
- Slide the 2 connectors (2)
onto the bulk head connector (1).
Caution: Improper routing of the wire harness assembly may damage the inflatable
restraint steering wheel module coil. This may result in a malfunction of
the coil, which may cause personal injury.
- Install the wire harness strap (2) into the steering
column tilt head assembly (1).
- Install the wire harness straps (3) onto the wire harness
assembly (4).
- Install the wire harness assembly (4) into the wire harness
strap (5).
- Install the upper and lower trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Enable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.