For 1990-2009 cars only
Sealed Beam Headlamp
- Remove the four retainer screws and the retainer from the headlamp.
- Pull the connector out and unplug the lamp.
- Plug the new lamp into the connector.
- Reverse Steps 1 and 2 to reinstall the headlamp.
Composite Headlamps
- Open the hood. See Hood Release for more information.
- Remove the two screws from the sidemarker/turn signal lamp assembly.
- Completely remove the sidemarker/turn signal lamp assembly by pulling it out and disconnecting the sidemarker/turn signal lamp sockets from the lamp. Replace the sidemarker/turn signal bulb with a new one if it needs to be replaced.
- Remove the screw located behind the corner reflector to remove the entire corner reflector.
- Remove the remaining three screws, the first one from the corner reflector pocket and the two remaining from the composite assembly.
- Remove the composite assembly.
- Turn the halogen bulb counterclockwise to remove it from the assembly.
- Install the new bulb into the composite assembly by turning it clockwise until it is completely tightened.
- Reinstall the composite assembly by installing and tightening all of the screws previously removed.
