Removal Procedure
- If necessary, remove the engine sight
shield. Refer to
Upper Intake Manifold Sight Shield Replacement
in Engine Mechanical - 4.8L, 5.3L, and 6.0L, or
Upper Intake Manifold Sight Shield Replacement
in Engine Mechanical - 8.1L.
- Remove the engine wiring harness ground bolt.
- Reposition the engine wiring harness ground and ground strap.
- Remove the ground strap nut from the stud
at the front of dash.
- Remove the ground strap from the stud.
Installation Procedure
- Install the ground strap to the stud.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the ground strap nut to the stud at the front of dash.
Tighten
Tighten the nut to 9 N·m (80 lb in).
- Position the ground strap and engine wiring
harness ground.
- Install the engine wiring harness ground bolt.
Tighten
Tighten the bolt to 16 N·m (12 lb ft).
- If necessary, install the engine sight shield. Refer to
Upper Intake Manifold Sight Shield Replacement
in Engine Mechanical - 4.8L, 5.3L, and
6.0L, or
Upper Intake Manifold Sight Shield Replacement
in
Engine Mechanical - 8.1L.