Cruise Control Switch Indicator Inoperative. Chevrolet Avalanche

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2007 🢒 Avalanche - 2WD 🢒 Engine 🢒 Cruise Control 🢒 Cruise Control Switch Indicator Inoperative

Diagnostic Instructions

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

The body control module (BCM) monitors the cruise control indicator switch. When the cruise on/off switch is pressed ON, the cruise control switch is closed and the signal circuit is low. When the cruise on/off switch is pressed OFF, the cruise control switch is open and the signal circuit is high.

Reference Information

Schematic Reference

•	Cruise Control Schematics

•	Body Control System Schematics

•	Steering Wheel Schematics

Connector End View Reference

•	Secondary/Configurable Control Connector End Views

•	Data Communication Connector End Views

Electrical Information Reference

•	Circuit Testing

•	Connector Repairs

•	Testing for Intermittent Conditions and Poor Connections

•	Wiring Repairs

Scan Tool Reference

Scan Tool Data List

Circuit/System Testing

Ignition OFF, disconnect the cruise control switch assembly.
Connect a fused jumper between the voltage signal circuit and the low reference circuit.
Ignition ON, observe the Cruise On/Off Switch parameter.

⇒	If the Cruise On/Off Switch parameter displays ON, replace the cruise control switch assembly.

⇒	If the Cruise On/Off Switch parameter displays Off, test the voltage signal circuit and the low reference circuit for an open, or for a high resistance.

⇒	If all circuits test normal, replace the BCM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

•	Steering Wheel Control Switch Assembly Replacement

•	Control Module References for BCM replacement, setup, and programming