GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Avalanche - 2WD 🢒 Body Hardware and Trim 🢒 Interior Trim and Paneling 🢒 Body Lock Pillar Garnish Molding Replacement

Body Lock Pillar Garnish Molding Replacement Avalanche/Escalade EXT


Object Number: 1702684 Size: MF

Callout

Component Name

Preliminary Procedures

  1. Disable roof rail SIR system. Refer to SIR Disabling and Enabling .
  2. Remove rear side door sill plate. Refer to Rear Side Door Sill Plate Replacement .

1

Body Lock Pillar Garnish Molding Plug

2

Body Lock Pillar Garnish Molding Screw

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

3

Removable Midgate Hinge Finish Cover

4

Rear Belt Assembly Anchor Bolt

Tighten
70 N·m (52 lb ft)

5

Body Lock Pillar Garnish Molding Assembly

Tighten
43 N·m (32 lb ft)

Tip

  1. Remove seat belt D-ring from the adjuster assembly.
  2. Route seat belt through garnish molding.

6

Body Lock Pillar Garnish Molding Retainers (Qty: 5)

Body Lock Pillar Garnish Molding Replacement Extended Wheelbase


Object Number: 1685182 Size: MF

Callout

Component Name

Preliminary Procedures

  1. Disable roof rail SIR system. Refer to SIR Disabling and Enabling .
  2. Remove rear side door sill plate. Refer to Rear Side Door Sill Plate Replacement .

1

Body Lock Pillar Garnish Molding Plug

2

Body Lock Pillar Garnish Molding Screw

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

3

Body Lock Pillar Garnish Molding Assembly

Tighten
35 N·m (25 lb ft)

Tip

  1. Remove seat belt D-ring from the adjuster assembly.
  2. Route seat belt through garnish molding.

4

Body Lock Pillar Garnish Molding Clip (Qty: 10)

Body Lock Pillar Garnish Molding Replacement Standard Wheelbase


Object Number: 1657790 Size: MF

Callout

Component Name

Preliminary Procedures

  1. Disable the roof rail SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the rear side door sill plate. Refer to Rear Side Door Sill Plate Replacement .
  3. Fold the rear seat up and forward.
  4. Reposition the rear side door weatherstrip off the molding.

1

Body Lock Pillar Garnish Molding Plug

2

Body Lock Pillar Garnish Molding Screw

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

3

Body Lock Pillar Garnish Molding Assembly

Tighten
35 N·m (25 lb ft)

Tip

  1. If equipped with rear folding seat, disconnect the electrical connectors.
  2. Remove seat belt D-ring from the adjuster assembly.
  3. Route seat belt through garnish molding.

4

Body Lock Pillar Garnish Molding Clip (Qty: 10)