GM Service Manual Online
For 1990-2009 cars only

Rear Seat Back Cushion Latch Cable Replacement Tahoe/Yukon/Escalade with Bucket


Object Number: 1684828  Size: MF

Callout

Component Name

Preliminary Procedure

Remove the rear seat. Refer to Rear Seat Replacement .

1

Rear Seat Cushion Trim Panel

Refer to Rear Seat Cushion Trim Panel Replacement .

2

Rear Seat Recliner Handle

Refer to Rear Seat Recliner Handle Replacement .

3

Rear Seat Recliner Outer Finish Cover

Refer to Rear Seat Cushion Outer Trim Panel Replacement .

4

Rear Seat Recliner Inner Finish Cover

Refer to Rear Seat Cushion Inner Panel Replacement .

5

Rear Seat Riser Finish Cover Screw

Notice: Refer to Fastener Notice in the Preface section.

Tip
Tilt the seat assembly up and forward to gain access to remove the screw.

Tighten
2 N·m (18 lb in)

6

Rear Seat Riser Finish Cover

7

Rear Seat Latch Cable

Procedure

  1. The rear seat latch cable is self-adjusting, the seat must be in the upright position and fully locked in place.
  2. Both the sync cable in-line adjusters must be open with the button pulled out.
  3. Ensure that both the inboard and the outboard release levers are in the fully locked position.
  4. Push both the inline sync cables adjuster buttons in.

8

Rear Seat Back Cushion Latch Cable

Procedure

  1. The rear seat back cushion latch cable is self-adjusting, the seat must be in the upright position and fully locked in place.
  2. Both of the cable in-line adjusters must be open with the button pulled out.
  3. Ensure that both the inboard and the outboard release levers are in the fully locked position.
  4. Push both of the inline cables adjuster buttons in.