Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Open the starter solenoid cable cover at the positive battery terminal.
3. Loosen the starter solenoid cable nut (5).
4. Remove the starter solenoid cable from the positive battery terminal.



5. Remove the right front fender rear upper brace bolts and the brace.



6. Remove the battery hold down retainer bolt and the retainer.
7. Remove the battery.

1. Install the battery.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the battery hold down retainer and the bolt.

Tighten
Tighten the retainer bolt to 25 N·m (18 lb ft).




3. Install the right front fender rear upper brace and the bolts.

Tighten
Tighten the brace bolts to 9 N·m (80 lb in).




4. Install the starter solenoid cable to the positive battery terminal.
5. Tighten the starter solenoid cable nut (5).

Tighten
Tighten the solenoid cable nut to 5 N·m (44 lb in).

6. Close the starter solenoid cable cover at the positive battery terminal.
7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .