For 1990-2009 cars only
- Install the pump housing (458) onto the pump housing (413).
- Install 2 of the cover bolts (408) to position and retain the body to the base.
- Insert the oil pump slide seal (415) and pump slide seal (414) into the pump housing (458).
- Insert the pump slide (412) into the pump housing (458).
- Install the slide spring (416) into the pump housing (458).
- Install the inner vane ring (410) into the pump housing (458).
- Insert the rotor (456) into the pump housing (458).
- Install the pump vanes (457) into the rotor (456). The pump vanes, when properly installed, must be flush with the top of the rotor (456).
- Install the outer vane ring (410) onto the top of the rotor (456).
- Install the oil pump cover (409) onto the oil pump housing (458).
- Install the oil pump cover bolts (408).
Important: Prior to assembling the oil pump, coat all wear or internal surfaces with clean engine oil.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the oil pump cover bolts to 12 N·m (106 lb in).
