Steering Effort Hard in One or Both Directions. Chevrolet Avalanche

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2008 🢒 Avalanche - 2WD 🢒 Steering 🢒 Power Steering 🢒 Steering Effort Hard in One or Both Directions

Steering Effort Hard in One or Both Directions Standard

Step	Action	Yes	No
1	Did you review the Power Steering System General Description and perform the necessary inspections?	Go to Step 2	Go to Symptoms - Power Steering System
2	Verify that the steering effort is hard in one or both directions. Does the system operate normally?	System OK	Go to Step 3
3	Perform the power steering test procedure. Refer to Power Steering System Test. Did you complete the procedure?	Go to Step 4	--
4	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3

Steering Effort Hard in One or Both Directions Two-Mode

Step

Action

Yes

Did you review the Power Steering System General Description and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Power Steering System

Verify the steering effort is hard in one or both directions.

Does the condition still exist?

Go to Step 3

System OK

Important: Position the front wheels straight ahead. DO NOT rotate the steering wheel more than one complete revolution either way from the center position.

Disconnect the steering shaft coupling from the steering gear. Refer to Steering Shaft Coupling Replacement.
Rotate the steering wheel in both directions.

Does the condition still exist?

Go to Step 7

Go to Step 4

Reconnect the steering shaft coupling to the steering gear. Refer to Steering Shaft Coupling Replacement.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Disconnect the outer tie rods from the steering knuckles. Refer to Steering Linkage Outer Tie Rod Replacement.
Rotate the wheels in both directions.

Does the condition still exist?

Go to Step 8

Go to Step 5

Reconnect the outer tie rods to the steering knuckles. Refer to Steering Linkage Outer Tie Rod Replacement.
Disconnect the EPS motor from the power steering gear and support the motor on the frame. Refer to Power Steering Assist Motor Replacement.
Rotate the steering wheel in both directions.

Does the condition still exist?

Go to Step 9

Go to Step 6

Replace the power steering assist motor. refer to Power Steering Assist Motor Replacement.

Did you complete the repair?

Go to Step 11

Inspect the following components for binding. If binding is present then replace the worn or damaged component:

•	Upper intermediate steering shaft and steering shaft coupling. Refer to Upper Intermediate Steering Shaft Replacement and Steering Shaft Coupling Replacement.

•	Steering column upper and lower bearings. Refer to Steering Shaft Upper Bearing Replacement and Steering Shaft Lower Bearing Replacement.

•	Steering column tilt head. Refer to Steering Column Replacement.

Did you complete the repair?

Go to Step 11

Inspect the following components for binding. If binding is present then replace the worn or damaged components:

•	Upper ball joints. Refer to Upper Control Arm Replacement.

•	Lower ball joints. Refer to Lower Control Arm Ball Joint Replacement.

Did you complete the repair?

Go to Step 11

Inspect the following components for binding. If binding is present then replace the worn or damaged component:

•	Outer tie rods. Refer to Steering Linkage Outer Tie Rod Replacement.

•	Inner tie rods. Refer to Steering Linkage Inner Tie Rod Replacement.

Did you complete the repair?

Go to Step 11

Go to Step 10

Replace the steering gear. Refer to Steering Gear Replacement.

Did you complete the repair?

Go to Step 11

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 4