Removal Procedure
- Relieve the fuel system
pressure. Refer to
Fuel Pressure Relief
.
- Remove the engine sight shield. Refer to
Upper Intake Manifold Sight Shield Replacement
in Engine Mechanical - 8.1L.
- Remove the fuel pressure regulator vacuum line.
- Clean any dirt from the fuel pressure regulator retainer and the
surrounding area.
- Remove the fuel pressure
regulator retainer (9).
- Remove the fuel pressure regulator (8).
- If necessary, remove the following:
7.3. | Regulator filter (12) |
Installation Procedure
- Install the following
onto the fuel pressure regulator (8).
1.1. | A NEW small O-ring (13) |
1.2. | Regulator filter (12) |
1.3. | A NEW large O-ring (11) |
- Lubricate the fuel pressure regulator large O-ring and the small
O-ring with clean engine oil.
- Push the fuel pressure regulator into the housing on the fuel
rail.
- Install a NEW fuel pressure regulator retainer (9).
- Install the fuel pressure
regulator vacuum line.
- Install the engine sight shield. Refer to
Upper Intake Manifold Sight Shield Replacement
in Engine Mechanical - 8.1L.
- Install the fuel fill cap.
- Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine
Electrical.
- Use the following procedure to inspect for leaks:
9.1. | Turn the ignition ON, with the engine OFF, for 2 seconds. |
9.2. | Turn the ignition OFF for 10 seconds. |
9.3. | Turn the ignition ON, with the engine OFF. |
9.4. | Inspect for fuel leaks. |