Removal Procedure
Important: When any molding is removed, all retaining clips needs to be replaced
with new ones if the molding is to be reused.
- Remove all retaining screws.
- Grasp the lower part of the molding.
- Pull outwards to release the clips from the body panel.
Installation Procedure
- Use a 3M™ scotch brite molding adhesive
remover disk P/N 07501 or equivalent to remove any adhesive tape on the body
panel.
- Peel off the adhesive tape protective lining.
- Align the retaining clips in their respective holes.
- Press firmly on the molding until all the retaining clips are
fully seated.
- Press on the top part of the molding so that the tape adheres
to the body panel.