GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Avalanche - 4WD 🢒 Body and Accessories 🢒 Body Rear End 🢒 Endgate Adjustment
  1. Lower the end gate.

    2. Object Number: 814590 Size: SH
  2. Remove the end gate handle bezel retaining bolts (1).

    3. Object Number: 814585 Size: SH
  3. Remove the end gate handle bezel (2) by using a flat-bladed tool to release the push-in retainers attached to the bezel directly below the handle (3).

    4. Object Number: 814588 Size: SH
  4. Release the right side end gate handle latch rod retainer (3).

    5. Object Number: 814586 Size: SH
  5. Release the left side end gate handle latch rod retainer (4).
  6. Adjust the latch by positioning the rod seating position in the retainer. Position each side equally.
  7. Attach the retaining clips.
  8. Close the end gate. Ensure that the end gate is latched securely.
  9. Open the end gate. Observe the ease of operation.
  10. Continue to adjust by repeating steps 6 through 9 until the desired operation is achieved.

    11. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  11. Attach the end gate handle bezel. Ensure that both push-in retainers are aligned correctly.

    12. Tighten
    Tighten the bolts to 9 N·m (7 lb ft).