Tools Required

J 25070 Heat Gun

Important: Be careful not to scratch or chip the paint.




1. Heat the spoiler using a heat gun. Hold the heat gun approximately 152 mm (6 in) from the surface.

Apply heat using a circular motion for about 30 seconds.

2. Starting from one end of the spoiler, peel off the Endgate surface using a flat-bladed tool.
3. Remove all adhesive from the body panel using a 3M™ stripe off wheel # 07498 or equivalent.

Important: Apply the molding in an environment free of dust and dirt. Dust and dirt could come in contact with the adhesive surface and prevent proper adhesion.




1. Clean the area where the replacement molding is to be mounted. Use a suitable solvent such as flash naphtha or a mixture of 50 percent isopropyl alcohol and 50 percent water.
2. Dry the area thoroughly.
3. Warm the body panel to a temperature range of 16-41°C (60-105°F) with a heat lamp or heat gun.
4. Ensure the spoiler is at a minimum temperature of 16°C (60°F).

If the temperature of the molding is below 16°C (60°F), warm up spoiler with a heat lamp or heat gun.

Important: Do not touch the adhesive surface when the tape is removed.

5. Remove the protective tape.
6. Without allowing the adhesive surface to touch the endgate, ensure the molding is aligned.
7. Install as shown in side view.
8. Press on the molding in order to install to the body.