After remote control door lock receiver assembly replacement, the following procedures must be performed in the order that they appear for the tire pressure monitor (TPM) System to function properly. The RCDLR also requires keyless entry transmitter programming after replacement. Refer to Transmitter Programming .

Since there are different tire types and pressure combinations for different vehicles, it is necessary to select the correct tire type and tire pressures for the vehicle being serviced.

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. With the scan tool select Vehicle Control System.
4. Select Module Setups.
5. Select Remote Control Door Lock Receiver.
6. Select Tire Type/Pressure Selection.
7. Select P-Metric Standard.
8. Select the front tire pressure as noted on the vehicle drivers door placard sticker.
9. Select the rear tire pressure as noted on the vehicle drivers door placard sticker.
10. Verify the selections made are correct and press the enter key. The scan tool will flash Procedure in Progress, then display Procedure Complete.
11. Press the exit key to escape.

After RCDLR assembly replacement, each of the tire pressure sensors unique identification codes must be learned into the RCDLR memory. Refer to Tire Pressure Sensor Learn .