DTC P0703. Chevrolet Avalanche

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2007 🢒 Avalanche - 4WD 🢒 Driver Information and Entertainment 🢒 Cellular, Entertainment, and Navigation 🢒 DTC P0703

Diagnostic Instructions

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

The body control module (BCM) monitors the stop lamp switch, mounted on the brake pedal. The BCM sends a GMLAN serial data message to the engine control module (ECM) indicating the status of the stop lamp switch.

Conditions for Running the DTC

The engine is ON.

Conditions for Setting the DTC

•	The ECM receives an invalid brake pedal status GMLAN serial data message from the BCM.

•	This diagnostic runs continuously.

Action Taken When the DTC Sets

•	The Cruise Control System is disabled.

•	The ECM stores the DTC information into memory when this diagnostic runs and fails.

•	The malfunction indicator lamp (MIL) will not illuminate.

•	All of the scan tool cruise control function switch parameters are set to Off.

Conditions for Clearing the DTC

•	A last test failed, or the current DTC, clears when the diagnostic runs and does not fail.

•	A history DTC clears after 40 consecutive warm-up cycles, if failures are not reported by this or any other emission related diagnostic.

•	Use the scan tool in order to clear the DTC.

Diagnostic Aids

Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records can help determine how many miles since the DTC set. The Fail Counter and Pass Counter can help determine how many ignition cycles that the diagnostic test reported a pass and/or a fail.

Reference Information

Schematic Reference

Cruise Control Schematics

Connector End View Reference

Data Communication Connector End Views

Electrical Information Reference

•	Circuit Testing

•	Connector Repairs

•	Testing for Intermittent Conditions and Poor Connections

•	Wiring Repairs

Circuit/System Testing

Important: Fix any Brake System related DTCs before using this diagnostic.

Important: This DTC may be stored as a history DTC without affecting the operation of the BCM. Do not replace the BCM if this DTC is stored only as a history DTC and is not retrieved as a current DTC.

Using a scan tool, is DTC P0703 current in the ECM?

⇒	If DTC P0703 is current in the ECM, replace the BCM.

⇒	If DTC P0703 is not current in the ECM, the system is OK.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for BCM replacement, setup, and programming