Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC U1814 00: Powertrain High Speed Communication Enable CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Accessory Wakeup Serial Data | U1814 | U0100 | -- | -- |
Circuit/System Description
The accessory wakeup serial data circuit is a positive voltage signal to wake up the engine control module (ECM), transmission control module (TCM), and the transfer case control module (TCCM) if equipped with RPO NP8. The signal is activated in 2 ways; any time the ignition switch is in the ACC or RUN position, or anytime the body control module (BCM) determines that communication is needed from the powertrain. When the ignition switch is in the ACC or RUN position, the accessory voltage circuit input to the BCM is internally connected to the accessory wakeup serial data circuit output, and voltage is supplied to the modules. The BCM also supplies voltage to the accessory wakeup serial data circuit when it determines that communication is necessary with the powertrain and the ignition is not in the ACC or RUN position such as during remote start.
Conditions for Running the DTC
| • | The system voltage is between 9-16 volts. |
| • | The vehicle power mode master requires serial data communication to occur. |
Conditions for Setting the DTC
The BCM senses a short to ground on the accessory wakeup serial data circuit.
Action Taken When the DTC Sets
| • | The modules use a default value for the missing parameters until the next ignition cycle. |
| • | The modules is never signaled, therefore the specific subsystems will not function. |
| • | The vehicle may not start. |
Conditions for Clearing the DTC
| • | A current DTC clears when the malfunction is no longer present. |
| • | A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction. |
Diagnostic Aids
Short to ground may also set multiple no communication codes for GMLAN high speed modules.
Reference Information
Schematic Reference
| • | DLIS Fuse and Ignition Switch in Power Distribution Schematics |
Connector End View Reference
Master Electrical Component List
Electrical Information Reference
Circuit/System Testing
- With the ignition OFF, disconnect the C1 harness connector at the ECM and TCM, and the C2 harness connector at the TCCM if equipped (RPO NP8) one at a time. After each disconnect, retest for current DTCs. DTC U1814 should remain current.
- Ignition OFF, disconnect the C4 harness connector at the BCM.
- Test for infinite resistance between the accessory wakeup serial data circuit and ground.
- If the circuit tests normal, replace the BCM.
| ⇒ | If the DTC becomes history, replace the module disconnected before the DTC became history. |
| ⇒ | If less than the specified range, test the serial data circuit for a short to ground. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for module replacement, setup, and programming
