Special Tools

J 41712 Oil Pressure Switch Socket

1. Remove the intake manifold. Refer to Intake Manifold Replacement.
2. Disconnect the engine harness electrical connector (1) from the oil pressure sensor.



3. If not equipped with active fuel management perform the following step, using J 41712 or equivalent, remove the oil pressure sensor (706) and washer (707).



4. If equipped with active fuel management perform the following step, using J 41712 or equivalent, remove the oil pressure sensor (706) and washer (707).

1. Apply sealant to the threads of the NEW oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers.

Caution: Refer to Fastener Caution in the Preface section.

2. If equipped with active fuel management perform the following step, using J 41712 or equivalent. Install the oil pressure sensor (706) and washer (707).

Tighten the sensor to 35 N·m (26 lb ft).




3. If not equipped with active fuel management, perform the following step, using J 41712 or equivalent. Install the oil pressure sensor (706) and washer (707).



4. Connect the engine harness electrical connector (1) to the oil pressure sensor. Tighten the sensor to 35 N·m (26 lb ft).
5. Install the intake manifold. Refer to Intake Manifold Replacement.