GM Service Manual Online
For 1990-2009 cars only

Liftgate Center Applique Replacement Escalade


Object Number: 1669836  Size: SF

Callout

Component Name

Procedure

  1. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement.
  2. Remove the 4 applique nuts from inside the liftgate panel.
  3. Release the 3 upper integral retainer clips from the exterior side of the liftgate panel.
  4. Disconnect the electrical connector.

1

Liftgate Center Applique Assembly Nut (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
6 N·m (53 lb in)

2

Liftgate Center Applique Assembly

Tip
Transfer the rear view camera (if equipped). Refer to Rearview Camera Replacement.

Liftgate Center Applique Replacement Tahoe, Yukon


Object Number: 1669868  Size: SF

Callout

Component Name

Procedure

  1. Open the liftgate.
  2. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement.
  3. Remove the 4 applique nuts from inside the liftgate panel.
  4. Release the 2 integral retainers from the exterior side of the applique.

1

Liftgate Center Applique Assembly Nut (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
6 N·m (53 lb in)

2

Liftgate Center Applique Harness Grommet

Tip
Ensure the grommet is secure to the liftgate panel hole prior to the installation of the applique.

3

Liftgate Center Applique Assembly

Tip
Transfer the rear view camera (if equipped). Refer to Rearview Camera Replacement.

Liftgate Center Applique Replacement GMC Yukon Hybrid 2 Mode


Object Number: 1964999  Size: SF

Callout

Component Name

Preliminary Procedures

  1. Open the liftgate.
  2. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement.
  3. Remove the 4 applique nuts from inside the liftgate panel.
  4. Release the 2 integral retainers from the exterior side of the applique.

1

Liftgate Center Applique Assembly Nut (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
6 N·m (53 lb in)

2

Integral Retainer (Qty: 2)

3

Rear Liftgate Harness Electrical Connector

Tip
Disconnect the electrical connector after releasing the retainers.

4

Liftgate Center Applique Assembly

Procedure

  1. Pull the applique rearward in order to release the 2 outer integral clips.
  2. Transfer the rear view camera (if equipped). Refer to Rearview Camera Replacement.