Preliminary Procedures

1. Remove the jack access cover and jack from the vehicle.
2. Remove the rear seat track finish cover.

1

Rear Seat Assembly Nut (Qty: 7)

Caution: Refer to Fastener Caution in the Preface section.

Tip
Remove the adjuster cover to access the nuts.

Tighten
45 N·m (33 lb ft)

2

Rear Seat Belt Buckle Anchor Nut

Tip
The nut is located behind the seat.

Tighten
45 N·m (33 lb ft)

3

Rear Seat Assembly

Procedure

Disconnect the electrical connector, if equipped.

1

Rear Seat Assembly Forward Nut (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Fold the seat forward and remove the floor cover to access the nuts.

Tighten
45 N·m (33 lb ft)

2

Rear Seat Assembly Rearward Nut (Qty: 4)

Tighten
45 N·m (33 lb ft)

3

Rear Seat Assembly

Procedure

1. Disconnect the electrical connector, if equipped.
2. Remove the seat with the aid of an assistant; the seat is very heavy.
3. It is important that the washers stay in the correct locations for installation to ensure seat alignment.

•	The rear inboard left side stud has one washer.

•	The rear inboard right side stud has two washers.

•	The front inboard right side stud has one washer.

1

Rear Seat Assembly Forward Nut (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Fold the seat forward and remove the floor cover to access the nuts.

Tighten
45 N·m (33 lb ft)

2

Rear Seat Assembly Rearward Nut (Qty: 4)

Tighten
45 N·m (33 lb ft)

3

Rear Seat Assembly

Procedure

Disconnect the electrical connector, if equipped.